Bitaxe.de
Noctua NF-A4x20 Silent Fan

Noctua NF-A4x20 Silent Fan

Quiet 40 mm PWM fan at 14.9 dB for Bitaxe and Nerdaxe boards

Item no.: 23269 · Manufacturer: Noctua

  • 40 × 40 × 20 mm – the standard size on many boards
  • 14.9 dB with an even running noise
  • 4-pin PWM at 5 V, the fan curve still applies
  • Swapped in a few minutes, no soldering
4,8 · 76 Reviews
€25.00 incl. VAT

plus shipping · −5% with Bitcoin: €23.75

In stock · ships within 24 h

Free shipping from 200 € Ships within 24 h 14-day right of withdrawal

Product information

Noctua NF-A4x20: quiet 40 mm fan for Bitaxe and Nerdaxe

The Noctua NF-A4x20 is a PWM fan measuring 40 × 40 × 20 mm and goes exactly where boards such as the Bitaxe Gamma carry a 40 mm fan from the factory. It runs at 5 V through the existing 4-pin connector, so your miner’s fan curve controls it just like the original – no adapter, no firmware changes.

At 14.9 dB it is the reason a miner moves from the shelf back onto the desk. Its 0.5 W of consumption is negligible next to that.

Why the swap is worth it

  • Calmer running: 14.9 dB and an even tone instead of bearing hum. What remains audible is mostly the airflow.
  • Fits without modification: same 40 mm frame, same 4-pin plug, same 5 V. No soldering, no adapter cable.
  • Control is preserved: speed readout and fan curve work after the swap exactly as before.
  • No cost factor: 0.5 W at 5 V changes your running costs practically not at all.

Does the NF-A4x20 fit your miner?

What matters is the 40 mm frame. That makes the fan fit the mounts of the Bitaxe Gamma, Nerdaxe Gamma and Nerdaxe Gaia, all of which ship with a 40 mm 5 V PWM fan.

Watch the 20 mm height: the NF-A4x20 is a thick 40 mm fan. In an open build that is irrelevant, but in a tightly cut case or above a tall tower cooler it can get close – check the space there first.

Who the NF-A4x20 is for

For everyone who runs their miner in a living room or office and sees the noise as the actual problem. If you run moderate settings anyway, the swap mostly does one thing: it gets quiet.

It is less suitable at the temperature limit. Customers say it openly: the Noctua moves slightly less air than the loud stock fan. If you run high clocks permanently, you gain quiet and lose headroom – then more cooling surface is the better step.

What you need to fit it

A screwdriver and a few minutes: undo the old fan, unplug it, plug in the new one and screw it down. Check the cable route while you do – customers report it gets tight when the header sits far away. Afterwards check fan speed and ASIC temperature in the web interface.

Accessories and sensible upgrades

  • ICE Tower Kit: more cooling surface so the quiet fan may spin slower.
  • Noctua NF-A6x15: the 60 mm sibling for boards and cases with a larger fan mount.
  • Cooling for heatsinks and kits that catch the heat before it reaches the fan.

Ready for a quiet Bitaxe setup?

The NF-A4x20 is the smallest sensible upgrade on an open-source miner: one component, a few minutes of work, and the device is allowed to stand where you work. It changes nothing about hash rate – and a lot about living with the miner.

Frequently asked questions about the Noctua NF-A4x20 Silent Fan

How loud is the Noctua NF-A4x20?

The fan is rated at 14.9 dB. In a normally furnished room it disappears into the background noise; what stays audible is the airflow rather than the bearing. How quiet your miner gets overall also depends on the fan curve.

Does the NF-A4x20 fit the Bitaxe Gamma?

Yes. The Bitaxe Gamma ships with a 40 mm 5 V PWM fan, which is exactly the frame size of the NF-A4x20. Plug and voltage stay the same, so no modification is needed.

Does the fan fit a NerdQaxe++?

No. The NerdQaxe++ uses a 92 mm fan, so a 40 mm one is too small. For 60 mm mounts there is the Noctua NF-A6x15.

What is the difference between the NF-A4x20 and the NF-A6x15?

Size, and therefore where they go: the NF-A4x20 measures 40 × 40 × 20 mm at 14.9 dB and 0.5 W, the NF-A6x15 measures 60 × 60 × 15 mm at 19.8 dB and 0.85 W. The 40 mm one replaces stock fans on Bitaxe and Nerdaxe boards, the 60 mm one belongs on 60 mm mounts.

Does the Noctua cool worse than the original fan?

It moves slightly less air – customers say so openly, and that is the price of the quiet. In normal operation it barely matters; with heavily overclocked settings you should watch the ASIC temperature after the swap.

How much electricity does the fan use?

0.5 W at 5 V.

Is the fan PWM controlled?

Yes, it has a 4-pin cable and is controlled by your miner’s fan control. Speed readout and fan curve work after the swap as before.

How long is the cable?

We do not state a cable length here, because it can differ between batches. From the reviews we do know: in builds with a long path to the header it gets tight. If your fan header sits far from the fan mount, plan the cable route beforehand.

How do I swap the fan?

Disconnect the miner from power, unscrew the old fan and unplug it, fit the Noctua in the same orientation and plug it in. Customers typically need only a few minutes.

Will my miner get hotter?

Usually by a few degrees, depending on heatsink, location and settings. If you want to keep the temperature, combine the quiet fan with more cooling surface from the cooling category.

Is the fan worth it if I want to overclock?

Only to a degree. Overclocking needs airflow, not silence – there a bigger heatsink is the more effective step.

Does the NF-A4x20 fit the NerdQaxe Performance Case?

No, the rear of the NerdQaxe Performance Case is prepared for two 60 mm fans. The NF-A6x15 is the right size for that.

Why buy from Bitaxe.de?

Free shipping from 200 €

Free shipping to almost every EU country from 200 €, shipping to the EU and Switzerland with UPS and a tracking link. Items in stock leave within 24 hours, with no customs surprises inside the EU.

Truly open source

Bitaxe, Nerdaxe, NerdQaxe & co. are open hardware running open firmware (AxeOS or NerdOS): you set pool, clock and voltage yourself. No cloud account, no vendor lock-in, no black box.

CE, warranty & returns

Every product carries the CE marking. Plus statutory warranty and a 14-day right of withdrawal for a safe order. If something is not right, we find a solution with you, person to person.

Direct support

Questions about setup, pool, firmware or your order? By email or Telegram you get help from someone who runs these devices themselves, in English or German, beginners welcome.

Customer reviews

4.8 / 5 · 76 reviews from customers who bought this product from us.

All reviews
08.11.2026
Superschnelle Lieferung. Die Installation des neuen Lüfters verlief ohne Probleme. Kleines Manko: Warum schickt Ihr keine Schrauben mit; dachte die wären dabei? Nun ja die Schrauben vom alten Lüfter hab ich dann genommen, aber der Bitaxe läuft jetzt wieder flüsterleise und hab sogar ihn noch etwas angepasst. Sehr gut!
Martin Verified purchase
28.09.2026
Back for a second order, this time just the fan! The Gamma I got here last winter has been hashing away on my desk ever since, and its stock fan was the one thing I never made peace with. Swapping it took five minutes, most of which I spent turning the Noctua over in my hand because it feels so solid. AxeOS 2.15.3 picked it up straight away, auto fan keeps the chip in a sensible range and the high-pitched whine is gone. Then there's the colour. My girlfriend asked whether I had glued a piece of chocolate onto the miner, which is fair, but the beige and brown has grown on me and actually looks quite charming next to the bare circuit board. Let's see what I come back for next time.
Josh Verified purchase
12.09.2026
Kollegen haben mich in Videocalls schon öfter gefragt ob bei mir im Hintergrund ein Föhn läuft. Das war der Gamma auf dem Sideboard hinter mir mit seinem Originallüfter. Also hab ich mir den Noctua geholt und letzte Woche eingebaut. Der Unterschied ist deutlich: statt dem hohen Sirren ist da jetzt nur noch ein leichtes Pusten das im Call niemand mehr mitbekommt. Ganz lautlos ist er natürlich nicht und wenn man ihn manuell auf 100 % stellt hört man ihn schon. Im Automatikbetrieb dreht er bei mir aber gemütlich vor sich hin. Ein paar Tage danach hab ich dann auch noch auf pool.bitaxe.de umgestellt weil ich eh schon am Basteln war. An der Temperatur hat sich durch den Lüfter nur wenig getan. Bisher hat keiner mehr nach dem Föhn gefragt.
Jonas Verified purchase
12.09.2026
Took me five minutes to swap and the noise difference is big, only thing is the cable is a bit short, so it now runs straight across the heatsink.
Maarten Verified purchase
11.09.2026
Saubere Sache am Gamma 602, und die Lieferung ging auch flott! Ich fahre den Lüfter manuell mit festen 75 %, damit liegt die ASIC-Temperatur ein bisserl höher als mit dem alten Propeller, aber weit weg von jeder Überhitzungsgrenze. Bei dem Wert ist der Noctua ein dezentes Fauchen, der Originallüfter war da schon richtig penetrant.
Korbinian Verified purchase
11.09.2026
Cable abit short, but quick delivery, temps fine!
Dylan Verified purchase
Show all 76 reviews

Related guides

Setup, pool, cooling, power supply and sensible upgrades for your setup.

You might also like

Noctua NF-A4x20 Silent Fan

€25.00