Was unsere Kunden sagen
Alle Bewertungen aus bitaxe.de – ohne Auswahl, ohne Filter.
4,8
1.292 Bewertungen
So kommen Bewertungen zustande
Bewertungen stammen von Kunden, die das Produkt bei uns gekauft haben.
- Einige Tage nach der Zustellung bekommen Käufer per E-Mail einen persönlichen Bewertungslink. Nur darüber lassen sich neue Bewertungen abgeben.
- Wir zeigen alle Bewertungen, unabhängig von der Sternzahl.
- Geprüft wird nur auf beleidigende oder werbliche Inhalte.
Gefiltert nach 5 Sternen (1.098). Filter entfernen
5 von 5 Sternen Verifizierter Kauf
Spartanisch verpackt, aber darum geht es ja nicht. Ab Werk lief der Lüfter auf Anschlag, das ist bei der aktuellen Firmware offenbar so, bis man die PID-Regelung einschaltet. Mit Zieltemperatur 60 liegen die vier Chips jetzt alle knapp darunter, und der 92er rauscht hörbar, aber gleichmäßig im Hintergrund.
5 von 5 Sternen Verifizierter Kauf
Runs 650 MHz all day for about 5.2 TH/s, which makes my Gamma look like a warm-up act. The printed stand is fine, it lives on a shelf anyway.
5 von 5 Sternen Verifizierter Kauf
De boekenkast in de werkkamer is sinds eind augustus een klein bouwproject geworden. Eerst stond de miner gewoon op het meegeleverde 3D-geprinte standaardje, dat prima werkt, al zag mijn vriendin meteen dat je de laagjes van de print kunt zien. Daarna heb ik een hele plank vrijgemaakt, de boeken liggen nu in een doos op zolder, zodat de ventilator van 92 mm aan alle kanten vrij kan blazen. Mijn vriendin vond het eerst onzin, inmiddels laat ze het schermpje aan visite zien en legt ze uit wat hashrate is, half correct. Op stock haalt hij steeds 4,8 tot 4,9 TH/s en de chips blijven netjes rond de 58 graden met de ventilator op automatisch. De plank erboven wordt deze herfst lekker warm, wat de kat ook al ontdekt heeft. Misschien komt er nog de losse houder bij, maar zo staat hij er eigenlijk ook al prachtig bij!
5 von 5 Sternen Verifizierter Kauf
Auf das Gerät musste ich gut zwei Wochen warten, weil es bei der Bestellung nicht vorrätig war, das stand im Shop allerdings auch so dabei. Seit es läuft, zeigt die Weboberfläche für die vier ASICs Werte zwischen 55 und 58 Grad bei einem Ziel von 60. Die Spannungsregler liegen mit etwa 72 Grad darüber, was bei dieser Bauweise normal sein soll. Für ein Gerät im fensterlosen Abstellraum ist das ein entspanntes Bild.
5 von 5 Sternen Verifizierter Kauf
Netzteil reicht sogar für ein bisschen mehr Takt!
5 von 5 Sternen Verifizierter Kauf
Packaging is as basic as it gets, one carton and a bit of foam, but nothing arrived damaged. Getting it on my wifi took one try, I followed the leaflet in the box and read the IP off the screen afterwards. The fan seemed loud to me until a friend showed me the target temperature setting, now it mostly just hums. Four months later I still flip through the display pages more than I'd like to admit.
5 von 5 Sternen Verifizierter Kauf
Lo tengo desde finales de agosto en el despacho de casa, encima de un mueble bajo junto al router, y estoy encantado. Al principio me preocupaba el calor, porque aquí en septiembre todavía teníamos 30 grados, pero los cuatro chips se han mantenido alrededor de 60 con el control automático del ventilador. Ahora que refresca, el despacho amanece calentito y el ventilador gira mucho más tranquilo. Lo que más me gusta es la pantalla: hashrate, temperaturas, la mejor dificultad y la IP, todo a la vista sin abrir el navegador, y con los dos botones vas pasando de una página a otra. Mi hijo de diez años ya se sabe qué significa cada número y tambien me corrige cuando me equivoco. Antes tenía un Bitaxe de un solo chip y la diferencia es enorme, y eso con un único enchufe. Haber si algún día cae un bloque, mientras tanto me lo paso en grande mirando los números.
5 von 5 Sternen Verifizierter Kauf
Numbers are right where they should be after three days on the homelab shelf: 4.88 TH/s average from the four BM1370 chips at stock and 77 W on the dashboard against 87 W on my smart plug. ASICs hold 57 to 59 with PID set to 60 and the VRs are the warm spot in the mid 70s which seems normal. It adds some whoosh next to the switch but my NAS was never silent either. Already eyeing the spot for a second one!
5 von 5 Sternen Verifizierter Kauf
pid-ziel 60 grad, und die vier asics halten sich brav daran: je nach raumtemperatur 55 bis 59 grad, wobei immer derselbe chip ein, zwei grad vorne liegt. die spannungsregler sind mit 73 bis 77 grad das wärmste auf dem board, das kannte ich schon aus dem forum, und bei werkstakt ist das kein thema. bis zur abschaltung bei 70 grad an den asics ist reichlich luft, selbst als das arbeitszimmer am wochenende bei geschlossenem fenster auf 24 grad kam. den mitgelieferten ständer habe ich nach drei tagen gegen die separat mitbestellte halterung getauscht, weil ich unter dem board mehr luft wollte. ob das messbar etwas bringt? die regler sind seitdem im schnitt vielleicht zwei grad kühler, das kann aber genauso gut am herbst liegen. optisch ist es auf jeden fall ein gewinn, und das teil steht jetzt bombenfest auf dem schreibtisch. als nächstes kommen 625 mhz dran, bin gespannt, was die temperaturen dazu sagen!
5 von 5 Sternen Verifizierter Kauf
Mit dem Serienkühler war bei 550 MHz Schluss jetzt läuft der Gamma mit 625 MHz und der Noctua bleibt dabei leise. Nach einer Woche unter meiner Zieltemperatur und keine Abschaltung.
5 von 5 Sternen Verifizierter Kauf
regalo para mi padre y la configuracion la hice yo en diez minutos. La interfaz web con frecuencia y voltaje es una joya y él ya no suelta la pantalla
5 von 5 Sternen Verifizierter Kauf
Reached Portugal way quicker than I expected, good thing too, since my NerdQaxe++ display had been flickering for a week before it quit. Same LILYGO board as stock.
5 von 5 Sternen Verifizierter Kauf
Blitzschnell da, Halterung sizt knapp, sonst top!
5 von 5 Sternen Verifizierter Kauf
Meine Frau hat beim Umbau gefragt, ob aus dem Gamma jetzt eine kleine Heizung wird, so sehen die vier Kupferröhrchen aus. Eher umgekehrt: Der Chip bleibt seit Dienstag so kühl, dass ich mich erstmals eine Frequenzstufe höher getraut habe, und die Hashrate ist spürbar gestiegen. Vorher hat der kleine Lüfter beim Fernsehen genervt, jetzt höre ich vom Wohnzimmerregal eher den Kühlschrank. Unser Großer wollte wissen, wo das Wasser durchläuft, und war enttäuscht, dass da keins ist. Drei Tage erst, aber ich bin begeistert!
5 von 5 Sternen Verifizierter Kauf
Went from stock to 650 MHz at 1250 mV, chip still under the 60 degree target, fan nowhere near full. A month later the average sits close to 1.5 TH/s.
5 von 5 Sternen Verifizierter Kauf
Flacher Riese! In zehn Minuten auf dem Nerdaxe.
5 von 5 Sternen Verifizierter Kauf
Measured properly before swapping: fan pinned at 35 percent, stock clock, chip in the low 60s on the original cooler. With the four heatpipes pulling the heat out into the wide fin block the same test lands in the mid 40s, so roughly fifteen degrees lower then before. Back on automatic with a 60 degree target the Noctua barely leaves the minimum speed I set, and the block and it's fins stay lukewarm under load. Two weeks only, but the numbers have not moved.
5 von 5 Sternen Verifizierter Kauf
Take this as a mounting report rather than a verdict, the kit is three days old. My relationship with this hobby is odd anyway: the Gamma does its 1.2 TH/s, the electricity meter barely notices, and nobody here expects it to ever pay for itself. What I like is a small open piece of hardware I am allowed to modify, and this kit is exactly that. Getting the stock cooler off took longer than fitting the new one, the old paste had set like glue. Clean the chip, a rice grain of the included paste, bracket around it, four spring pins through the board, fan onto the 4-pin header. The block is low but much wider than the PCB, fine on an open desk, a problem in any box. Same 525 preset, target left at 60, and the Noctua settles far below where the stock 40 mm used to hover while the chip reads clearly cooler. My Nerdaxe Gamma is next, its firmware runs the fan flat out until you enable PID, so it needs this more. Sore point is the price: for a heatsink, a fan and a printed bracket it is not cheap, Noctua or not.
5 von 5 Sternen Verifizierter Kauf
kupovala jsem ho hlavně proto, že jsem chtěla pochopit, jak těžba bitcoinu vlastně funguje, a zároveň jsem se bála velkých účtů za proud. ten strach byl zbytečný. podle webového rozhraní si bere kolem 15 w, to je míň, než spotřebuje topení v našem akváriu. nastavení jsem zvládla sama, jen heslo k wifi jsem napoprvé napsala špatně. ukazuje něco přes 1,1 th/s a pořád mě baví ho sledovat.
5 von 5 Sternen Verifizierter Kauf
Before this holder my NerdQaxe++ slid around the desk every time I touched a cable, and in the first weeks that was often. Now it stays put and the board is not lying flat on the desk anymore, so air can reach the underside as well. Temperatures did not change, but I did not expect that from a stand. The ++ version matched the board without fiddling, screw holes lined up, screws were in the bag, nothing else to buy.
5 von 5 Sternen Verifizierter Kauf
Love that it stands upright on the printed bracket with the board fully exposed, like a little piece of lab equipment on the shelf. The screen is the star: hashrate, temps and best difficulty in big friendly digits, and visitors ask what it is. Only wish is a way to dim the display, at night it lights the living room like a tiny billboard, so it now faces the wall. Hashrate hovers around 1.1 TH/s and it has not missed a beat in ten days.
5 von 5 Sternen Verifizierter Kauf
Couldn't leave it on stock settings, obviously. At the factory 525 MHz / 1150 mV it showed about 1.1 TH/s with AxeOS reporting a bit under 16 W, roughly what the expected hashrate figure promises. First I updated to 2.10.0 (two files in the web UI, settings survived) because I wanted the new minimum fan speed option. Then I went up slowly: 550 at stock voltage for a day, then 575 MHz at 1200 mV for another. That one is the keeper, around 1.2 TH/s at 18 to 19 W, ASIC at 62 °C with the fan near 55 %. A quick go at 600 brought a handful of rejected shares and a fan I could hear across the room, so no thanks. Pool-wise it points at public-pool.io, with a second solo pool as fallback, purely for fun, the odds are what they are. At these wattages electricity is a non-topic, a bit over 13 kWh a month by my maths. It has quickly become my favourite thing to fiddle with after work.
5 von 5 Sternen Verifizierter Kauf
Gamma 601, 575 MHz, chip stays under 50.
5 von 5 Sternen Verifizierter Kauf
Paket kam flott, mein Bitaxe verträgt eine Taktstufe mehr, ohne heiß zu werden. Die Paste im Set ist aber so knapp, dass der zweite Anlauf eng wurde, muss das sein?